Samsung WEC8500 Operation Manual page 420

5
WEC8500/configure/security/tacacs 1# retransmit-interval [RETRY_INTERVAL]
WEC8500/configure/security/tacacs 1# retransmit-count [FO_RETRY_COUNT]
6
WEC8500/configure/security/tacacs 1# source-ip [IP_ADDRESS]
7
WEC8500/configure/security/tacacs 1# status [STATUS]
8
WEC8500/configure/security/tacacs 1# exit
WEC8500/configure/security# exit
9
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Configure the items related to retransmissions in TACACS+
communications.
You can use default values without changing configuration.
Parameter
RETRY_INTERVAL
FO_RETRY_COUNT
If necessary, configure the source IP address of the TACACS+
message.
Parameter
IP_ADDRESS
Configure whether to transfer packets to the TACACS+ server. You can
use default values without changing configuration.
Parameter
STATUS
Exit TACACS+ server configuration and then security configuration
mode.
You can view configuration information by using the 'show security
tacacs server config' and 'show security tacacs server detail [SERVER
ID]' commands.
Description
Retransmission interval for a TACACS+ message
(unit: seconds, range: 1-5, default value: 3)
Maximum message retransmission count before a
TACACS+ server failover is attempted (range: 0-3,
default value: 2)
Description
Source IP address of the TACACS+ message
Note: it must be one of the IP addresses configured in
the W-EP wireless LAN system.
Description
Status indicating whether packets are transferred to the
TACACS+ server (default value: enable)
401