Management Interface Configuration; Figure 92. Apc List Management Window - Samsung WEC8500 Operation Manual

ME
4
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Controller>  <APC Lists> menu in the sub-menus. Operator can add a new APC by
clicking the <Add> button in the figure.
Figure 92. APC List Management Window

Management Interface Configuration

The APC can communicate with a W-EP wireless LAN AP using management interface.
This is one of the information that must be configured first of all for wireless LAN service.
Configuration using CLI
To configure management interface, execute the command as follows:
1
WEC8500# configure terminal
WEC8500/configure#
2
3
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
o change-apc [CURRENT_APC_NAME] [NEW_APC_NAME]
o change-mac [APC_NAME] [MAC_ADDRESS]
Parameter
APC_NAME
CURRENT_APC_NA
NEW_APC_NAME
IP_ADDRESS
parameter value of 'show system info' command.)
To check the configured APC list, execute the 'show apc-list' command.
Go to the configure mode of the CLI.
Configure a management interface.
o apc ap-mgmt-if [IP_ADDRESS]
Parameter
IP_ADDRESS
wireless LAN AP
To check the configured IP information, use the 'show apc summary'
command.
Description
APC name
Current APC name (before change)
APC name after change
APC MAC address (xx:xx:xx:xx:xx:xx)
In the APC system, enter the system mac address output
Description
IP address of APC that is used for communication with a W-EP
128