Samsung WEC8500 Operation Manual page 194

Access point controller
Hide thumbs Also See for WEC8500:
Table of Contents

Advertisement

WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
DHCP, Static or AP Followed.
 dhcp: Configures the AP IP operation type to DHCP
 static: Configures the AP IP operation type to static
 ap: Operates with an IP configured in an AP
o led-config: Configures LED ON/OFF setting of the AP.
 on: Sets LED of the AP on.
 off: Sets LED of the AP off.
 off-time: Sets LED of the AP off only for specific hours.
o local-bridging: Configures WLAN-VLAN Mapping of the Local
Switching WLAN, ACL, and Pre-Authentication ACL of Captive Portal
for each remote AP.
 vlan-id: Configures a VLAN ID to allocate to the Local Switching
WLAN.
 acl-name: Configures an ACL name to allocate to the Local
Switching WLAN for packet allowance/blocking.
 pre-auth-name: Configures a Pre-Authentication ACL name for
Captive Portal operation of the Local Switching WLAN.
o location [STRING]: Configures the information of location where an
AP is installed.
o mac [MAC_ADDRESS]: Configures the MAC address of an AP
o max-echo-retransmit [COUNT]: Configures the maximum number of
retransmission times of an echo request message.
o max-retransmit [COUNT]: Configures the maximum number of
retransmission times of a CAPWAP control message.
o name [STRING]: Configures an AP name.
o native-vlanId [VLAN_ID]: Configures the native VLAN in an AP.
o primary-apc [APC_AME]: Configures the name of a primary APC.
o secondary-apc [APC_AME]: Configures the name of a secondary
APC.
o tertiary-apc [APC_AME]: Configures the name of a tertiary APC. The
WEC8050 model does not support the tertiary-apc function.
o repeater-whitelist [MAC ADDRESS]: Adds the Repeater AP Whitelist.
o report-interval [INTERVAL]: Configures the time interval for an AP to
transmit the description error to the APC (Unit: seconds)
o retransmit-interval [INTERVAL]: Configures the waiting time until the
AP retransmits a CAPWAP control message when there is no reply
from the APC (unit: seconds)
o ssh-enable: Configures whether to enable the SSH server of an AP.
o static-ip [IP_ADDRESS] [NETMASK] [GATEWAY]: Configures the
static IP address of an AP.
175

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wec8050

Table of Contents