Figure 226. Open Api Service Configuration Window - Samsung WEC8500 Operation Manual

Open API Service
The APC provides information about devices detected in the network through two types
of APIs. One is a polling API and the other is an event-based API.
1
2
The open API service should be enabled and the accounts for that service should be
created before using this service.
Service Activation
Configuration using CLI
To activate open API service, execute the command as follows:
1
WEC8500# configure terminal
WEC8500/configure # open-api
WEC8500/configure/open-api #
2
WEC8500/configure/open-api # enable
3
WEC8500/configure/open-api # no enable
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Administrator> and then select
<OPEN API>  <Service> menu in the sub-menu.
Figure 226. Open API Service Configuration Window
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
The polling API is the method based on HTTP get/response protocol with
a specific URL to provide information such as AP list, station list, rogue
AP list, and rogue station list.
Event-based API provides RSSI data through HTTP post message to the
registered external server periodically.
Go to the configure  open-api configuration mode of CLI.
Execute [enable] command
Execute [no enable] command to deactivate open API service
346