Figure 272. Ttacacs+ Server Configuration Window; Configuring Authentication Type Of Operator Account - Samsung WEC8500 Operation Manual

Configuration using Web UI
In the menu bar of <WEC Main Window>, select <Configuration>, and then select
<Security>  <AAA>  <TACACS+> in the submenus.
If you click the <Add> button in the TACACS+ initial window, you can add a TACACS+
server.
The server addition window is shown below.
Figure 272. TTACACS+ Server Configuration Window
SECRET
INTERVAL
COUNT
FAILOVER
ADDRESS

Configuring Authentication Type of Operator Account

The steps for configuring the authentication type of the operator account are as follows:
Configuration using CLI
1
WEC8500# configure terminal
WEC8500/configure#
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Item Description
INDEX (PRIORITY) ID that distinguishes TACACS+ server configurations
IP ADDRESS IP address of the TACACS+ server
SHARED SECRET Public key of the TACACS+ server
CONFIRM SHARED Re-enters the key for TACACS+ server communications for
confirmation
PORT NUMBER Communication
(range: 1-65,535, default value: 49)
RETRANSMIT Retransmission
(range: 1-5, default value: 2, unit: seconds)
RETRANSMIT Maximum message retransmission count before a TACACS+
BEFORE server failover is attempted (range: 0-3, default value: 2)
SOURCE IP Source IP address of the TACACS+ message
• Note: it must be one of the IP addresses configured in the W-EP
STATUS Status indicating whether packets are transferred to the
TACACS+ server (default value: enable)
Go to the configure mode of the CLI.
port number
interval
wireless LAN system.
of the TACACS+
for a TACACS+
server
message
402