Samsung WEC8500 Operation Manual page 315

WEC8500/configure/rrm/80211a/dcs# joint-algo-enable
5
WEC8500/configure/rrm/80211a/dcs# periodic-interval [value]
6
WEC8500/configure/rrm/80211a/dcs# channel-utilization-threshold [value]
7
WEC8500/configure/rrm/80211a/dcs# my-utilization-threshold [value]
8
WEC8500/configure/rrm/80211a/dcs# anchor-time start [value] end [value]
9
WEC8500/configure/rrm/80211a/dcs# channel [value]
10
WEC8500/configure/rrm/80211a/dcs# delayed-channel-change
11
WEC8500/configure/rrm/80211a/dcs# aware-option voice
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Execute the following command to change the execution interval. The
default value is 120 (seconds).
Execute the following command to change the Channel Utilization
threshold.
The default value is 80 (%).
Execute the following command to change the My Utilization threshold.
The default is 10 (%) for 802.11a and 40 (%) for 802.11b.
Execute the following command to set the anchor time. The default value
is start time 4, end time 5. If both start time and end time are set to the
same time, Anchor Run function is disabled.
Execute the following command to change the channels that is
automatically set by the DCS. Use the 'no' parameter to disable the
mode.
Execute the following command to use the Delayed Channel Change
function.
To disable the configuration, enter the 'no' parameter. The default is the
'Disable'.
The Delayed Channel Change function delays channel change instead
of changing it immediately when a channel becomes busy due to channel
utilization. If the anchor time is not configured, the default value is used
at 4 o'clock.
To use the Aware Option function, execute the following command. To
disable the configuration, enter the 'no' parameter. The Aware Option
does not change a channel if there is a specific condition. Therefore,
three functions are provided based on whether there is a voice, the
association of a station, or traffic in a station. The default is that only the
Voice Aware function is enabled. The Station Aware function specifies
the number of stations at the same time.
296