network
ospf
overflow
passive-interface
redistribute
router-id
summary-address
timers
WEC8500/configure/router/ospf 2# network ?
A.B.C.D
A.B.C.D/M
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Controller> <Network> <OSPF> <Network> menu in the sub-menus.
The OSPF initial window is shown below.
Configuration of Network Details
Configuration using CLI
1
WEC8500# configure terminal
WEC8500/configure# router ospf
WEC8500/configure# router ospf ?
1 - 10
2
WEC8500/configure/router/ospf 2# network ?
A.B.C.D
A.B.C.D/M
WEC8500/configure/router/ospf 2# network 100.100.100.1 ?
A.B.C.D
WEC8500/configure/router/ospf 2# network 100.100.100.1 255.255.255.0 ?
area
WEC8500/configure/router/ospf 2# network 100.100.100.1 255.255.255.0 ?
area
WEC8500/configure/router/ospf 2# network 100.100.100.1 255.255.255.0 area ?
0 - 4294967295
A.B.C.D
WEC8500/configure/router/ospf 2# network 100.100.100.1 255.255.255.0 area 3
<cr>
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Enable routing on an IP network
OSPF specific commands
Control overflow
Suppress routing updates on an interface
Redistribute information from another routing protocol
Router-id for the OSPF process
Configure IP address summaries
Adjust routing timers
Network number
OSPF network prefix
Go to configure ospf configuration mode of CLI.
OSPF process ID
Network configuration
Configure the ADDRESS, NETMASK, and AREA ID of a user-defined
network.
Network number
OSPF network prefix
OSPF wild card bits(network mask)
Set the OSPF area ID
Set the OSPF area ID
OSPF area ID as a decimal value
OSPF area ID in IP address format
?
71