Samsung WEC8500 Operation Manual page 153

START-END
TIME
3
WEC8500# configure terminal
WEC8500/configure# ap ap_1
WEC8500/configure/ap ap_1#
YPE
4
5
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Parameter Description
CAPWAP protocol. It is recommended not to use a different port
number if it is specially required.
FALLBACK Enter the time zone where an AP connected to the backup
(secondary or tertiary) APC can do fallback.
The input format is as follows:
• Format: hh:mm-hh:mm
• Example: 2:00-5:00  Fallback is available between 2 pm and 5
pm.
INTERVAL Configures the interval that an AP connected to the backup
(secondary or tertiary) APC attempts fallback (second).
If a specific time is not entered, the default is 120 seconds.
The minimum is 60 seconds and the maximum is 1800 seconds.
Enter into the configure  AP configuration mode of CLI and configure
a primary, secondary, and tertiary server. To make an AP operate in
redundancy configuration, configure the Discovery of the AP as 'apc-
referral'.
o discovery apc-referral
o primary-apc [APC_NAME]
o secondary-apc [APC_NAME]
o tertiary-apc [APC_NAME]
Parameter Description
APC_NAME Enter the name of an APC registered to redundancy.
• Primary apc: The first APC that the AP attempts to connect.
It is usually configured with the currently connected APC.
• Secondary-apc, tertiary-apc: APC that the AP attempts to connect
when there is no response from the primary-apc.
DISCOVERY_T Discovery Type
• ap-followed: Discovery type is set by AP.
• apc-referral: Discovery type is set by APC using the backup APC
lists.
To apply the priority of APC to which the AP will be connected,
operator needs to select the apc-referral.
• DHCP: Discovery type is interoperating with the DHCP server. To
use this mode, IP ADDRESS POLICY of the AP must be set to
DHCP.
• Auto: Discovery type is automatically changed by the AP for
automatic connection to the APC.
To check the configured apc list, execute the 'show apc summary'
command.
To check the redundancy information, execute the 'show redundancy
summary' command.
134