Figure 95. Redundancy Configuration Window - Samsung WEC8500 Operation Manual

6
Configuration using Web UI
1
2
Figure 95. Redundancy Configuration Window
DRESS
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
To check the configured AP profile, execute the 'show ap detail
[AP_PROFILE_ NAME]' command.
By referring to the 'APC List Management', add the APC list that will be
used as a backup APC.
In the menu bar of <WEC Main window>, select <Configuration> and
then select the <Controller>  <Redundancy> menu in the sub-
menus. Operator can add or delete the APC list that will be used for
redundancy. If necessary, operator can configure the fallback function.
Parameter Description
APC NAME Name of an APC to be added or deleted to/from redundancy
The APC must be an APC registered in the APC list.
MAC ADDRESS Because this is a MAC address configured during registration to the
APC list, an operator does not have to enter this at the redundancy
configuration stage.
IP_ADDRESS IP address of an APC to add
This address is an IP required by an AP to connect to the APC.
Therefore, you must enter the AP Management IP address of the
APC.
PORT CAPWAP PORT number of the APC to add
If no port number is entered, it is set to 5246, the default port number
of CAPWAP protocol. It is recommended not to use a different port
number if it is specially required.
PUBLIC_IP_AD PUBLIC IP address of the APC to add
This address is an IP required by an AP to connect to the APC. If
the APC is in the NAT environment, you must enter an official IP
configured in the NAT instead of the private IP of APC.
PUBLIC_PORT PUBLIC CAPWAP PORT number of the APC to add
This port number is required by an AP to connect to the APC. If the
135