Samsung WEC8500 Operation Manual page 178

•
•
•
•
•
When an AP group is added and the remote AP group is checked, APs included in the
AP group operates in the remote AP mode.
If an AP is added to or deleted from a remote AP group, the AP is rebooted and
reconnected to the APC. If an AP moves between remote AP groups, the AP is not
rebooted.
Addition/Removal Setting
Configuration using CLI
1
WEC8500# configure terminal
WEC8500/configure#
2
3
4
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Local Authentication
o Radius Server
Possible to set a Radius server which will authenticate a station
connecting to the remote AP.
o Remote AP User List
Possible to add or delete a user (station) to be managed in the remote
AP.
Role Based Access Control
o Possible to apply the ACL profile.
Tunnel Forwarding
o Possible to add the split-tunnel-ACL, PreAuth-ACL, and interface-
group settings of the WLAN set with the tunnelling mode. Possible to
add the split tunnel ACL settings of the WLAN set with the tunnelling
mode.
Local Bridging Forwarding
o Possible to add settings of VLAN ID, ACL, and Pre-Auth ACL of the
WLAN set with the local bridging mode.
DHCP
o Can use AP which is included in Remote AP Group as a DHCP
server.
Go to the configure mode of the CLI.
Create an AP group.
o ap-group[REMOTE_AP_GROUP_NAME]
Designate remote AP group properties to the AP group.
o remote-group
When disabling remote AP group attribute, use the 'no' parameter in front
of the ap-group command to delete the remote AP group.
o no ap-group[REMOTE_AP_GROUP_NAME]
159