group, configure the necessary settings. If the OVERWRITE AP CONFIG checkbox is
selected, the respective setting is applied to all APs within the group.
Figure 100.
General Configuration Window for AP Group
Adding/Removing APs
To aid management of APs in groups, the APC allows addition/removal of APs to/from
AP groups.
Configuration using CLI
1
WEC8500# configure terminal
WEC8500/configure#
2
3
4
Configuration using Web UI
In the menu bar of <WEC Main Window>, select <Configuration>, select <AP Groups>
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Go to the configure mode of the CLI.
Create an AP group or enter the AP group configuration mode.
o ap-group [AP_GROUP_NAME]
Add/remove an AP to/from the AP group. Use 'no' parameter in front of
the command to delete an AP from the AP group. However, you cannot
delete an AP from a default AP group. If you delete an AP from groups
other than the default group, the deleted AP is then included in the
default AP group.
o add-ap [AP_NAME]
o no add-ap [AP_NAME]
Use the 'show ap-group summary' command to check the AP group
information.
142