Interface Configuration
The WEC8500 interface consists of the following physical interface and virtual interface:
•
•
There are two types of WEC8050 interface as shown below; physical interface and virtual
interface:
•
•
Interface Management
The WEC8500 Management port is used to manage the WEC8500. It does
not support VLAN and its interface name is 'mgmt0'. The 8 ports at the right
side of Management port are 10/100/1000 BASE T-ports and their names
are
To the right side of the 10/100/1000 BASE T-ports, there are two Gigabit
ports, that is XE1 and XE2.
Configuration using CLI
To configure the interface related function, go to the interface mode by entering the
'interface [INTERFACE_NAME]' command in the configure mode. An example of entering
into the interface mode of the management port is shown below.
WEC8500# configure terminal
WEC8500/configure# interface mgmt0
WEC8500/configure/interface mgmt0#
The interface related CLI commands are as follows:
[ip address]
This is a command that configures a static IP address. The 'no' parameter is used to
delete the configuration.
•
•
•
[ip address dhcp]
This is a command that configures a dynamic IP address using DHCP. The 'no' parameter
is used to delete the configuration.
•
•
[shutdown]
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Physical interface of 11 ports except console port
1024 virtual interfaces using VLAN
Physical interface of 4 ports except console port
128 virtual interfaces using VLAN
ip address {A.B.C.D/mask length}
no ip address {A.B.C.D} {A.B.C.D}
no ip address {A.B.C.D/mask length}
ip address dhcp
no ip address dhcp
GE1-8.
47