Samsung WEC8500 Operation Manual page 202

AP SNMP Agent Configuration
The APC operator can configure SNMP Agent settings for all APs.
Configuration using CLI
Execute the following commands to configure the SNMP Agent settings of the AP:
1
WEC8500# configure terminal
WEC8500/configure# snmp
WEC8500/configure/snmp# ap
WEC8500/configure/snmp/ap#
2
TYPE
3
Configuration using Web UI
In the menu bar of <WEC Main Window>, select <Administration>, select <AP> in the
submenu, and then select <v1/v2c Community> or <v3 User> to configure the SNMP
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Go to configure  snmp  ap mode of CLI.
Configure the snap agent information of the AP.
Enable/disable SNMP of the AP.
o enable or no enable
Configure the SNMP port number of the AP.
o Port [PORT NUMBER]
Configure the Read Only Community Name of the AP.
o ro-community [COMMUNITY NAME]
Configure the Write Only Community Name of the AP.
o rw-community [COMMUNITY NAME]
Configure the user information of the AP.
o Use
r[USER
[AUTHENTICATION KEY] [PRIVATE PROTOCOL] [PRIVATE KEY]
Parameter
PORT NUMBER
COMMUNITY NAME
USER NAME
AUTHENTICATION
AUTHENTICATION KEY
PRIVATE PROTOCOL
PRIVATE KEY
Use the 'show snmp ap' command to retrieve the agent information
configured for the AP.
NAME] [AUTHENTICATION
Description
This is the SNMP port number.
This is the SNMP Read Only or Write Only Community
name.
This is the SNMP user name.
This is the SNMP authentication type. Either of the following
two can be selected:
• MD5
• SHA
A number in the range of 8 to 20 can be entered.
Either of the following two can be selected:
• DES
• AES
A number in the range of 8 to 20 can be entered.
TYPE]
183