Samsung WEC8500 Operation Manual page 253

Configuration using CLI
[Pool Creation]
The procedure of creating a pool in an internal DHCP server and entering into the pool
mode is as follows:
1
WEC8500# configure terminal
WEC8500/configure #
2
3
WEC8500# configure terminal
WEC8500/configure # [ip/ipv6] dhcp pool test
WEC8500/configure/[ip/ipv6]/dhcp/pool test#
[Configuring IP address]
Before configuring a DHCP pool, you should configure a network first. If the network is
not configured, you cannot execute other commands.
Enter the command as follows to configure the network bandwidth of a DHCP pool to
serve. Enter 'no' parameter to delete a configured network bandwidth. After entering a
separator '/' after an IP address, enter the length of a netmask address or enter a netmask
address after the IP address:
•
•
•
[Configuring IPV6 address]
Before configuring a DHCP IPV6 pool, you should configure a network.
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Go to the configure mode of the CLI.
Enter the '[ip/ipv6] dhcp pool' command. Use 'no' in front of the command
to delete a DHCP pool.
o ip dhcp pool [POOL_NAME]
o no ip dhcp pool [POOL_NAME]
o ipv6 dhcp pool [POOL_NAME]
o no ipv6 dhcp pool [POOL_NAME]
To check configuration information, use the 'show [ip/ipv6] dhcp'
command.
To configure the DHCP Pool related function, execute the command as
follows to go to the DHCP pool mode:
network [IP_ADDRESS] [NETMASK]
network [IP_ADDRESS]/[LENGTH]
no network
Parameter
IP_ADDRESS
NETMASK
LENGTH
Description
IP address
Netmask address
Netmask length
234