Setting Ap Group Parameter - Samsung WEC8500 Operation Manual

7
8

Setting AP Group Parameter

Station-based/AirTime-based Adaptive Load Balancing must set operating parameters to
the radio of the corresponding AP group because it operates in a radio unit of the AP
group.
Configuration using CLI
To set AP group parameters, execute the command as follows:
1
APC# configure terminal
APC/configure# ap-group lb
APC/configure/ap-group lb# load-balancing
APC/configure/ap-group lb/load-balancing#
2
APC/configure/ap-group lb/load-balancing# radio 1
APC/configure/ap-group lb/load-balancing/radio 1#
3
4
5
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
o calibration pc [NUMBER]
o calibration others [NUMBER]
Parameter
NUMBER
To exclude stations where the traffic occurs from load balancing, the
following option must be set (Default: no idle-station):
o idle-station
The following option must be configured to use the HandOver function
of Smart Service Link (default: no ssl-ho):
o ssl-ho
Go to the load-balancing configuration mode in configure  AP Group
of CLI.
Go to the radio to perform the Station-based Adaptive Load Balancing
function.
Activate load balancing in the corresponding radio.
o enable
Set the criteria of operation at the Load Balancing function.
o Criteria
Parameter
CRITERIA
Set the interval to attempt at the Station-based Adaptive Load Balancing
Description
RSSI calibration value (-dbm)
• Default value: 0 dbm
Description
• station: Station based Adaptive Load Balancing
• sticky: only sticky Station based Adaptive Load Balancing
• airtime: AirTime based Adaptive Load Balancing
341