Figure 299. Adding Snmp Community; Snmp Trap - Samsung WEC8500 Operation Manual

Figure 299. Adding SNMP Community

SNMP Trap

All the alarms of the APC system are basically transmitted to outside through the SNMP
trap. Therefore, to receive a system alarm from an external management server, the server
address must be registered as a trap target. The trap supports v1/v2.
Configuration using CLI
To add a SNMP trap target, execute the command as follows:
1
WEC8500# configure terminal
WEC8500/configure#
2
3
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Administrator> and then select the
<SNMP> <APC>  <Trap Receiver> menu in the sub-menus.
When you click the <Add> button in the Trap Receiver window, the trap creation window
is displayed. When you enter a configuration value and click the <Apply> button, the
configuration is applied.
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Go to the configure mode of the CLI.
Add a SNMP trap target.
o snmp trap [TRAP_VERSION] [COMMUNITY_NAME] [IP_VERSION]
[IP_ADDRESS] [PORT_NUMBER]
Parameter
TRAP_VERSION
COMMUNITY_NAME
IP_VERSION
IP_ADDRESS
PORT_NUMBER
To check the added trap target, use the 'show snmp trap' command.
Description
Trap version (v1/v2)
Name of a community to be transmitted
IP address type (v4/v6)
IP address to which a trap will be transmitted
Port number to which a trap will be transmitted (default:
162)
437