Figure 118. Adding Access Points - Samsung WEC8500 Operation Manual

Configuring MAC Address
Configuration using CLI
To configure AP information, execute the command as follows:
1
WEC8500# configure terminal
WEC8500/configure# ap [ap profile name]
WEC8500/configure/ap ap_1#
2
3
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Access Points> menu in the sub-menus.
1
2
Figure 118. Adding Access Points
Configuring AP Profile
Configuration using CLI
To configure an AP profile configuration, execute the command as follows:
1
WEC8500# configure terminal
WEC8500/configure# ap ap_1
WEC8500/configure/ap ap_1# profile
WEC8500/configure/ap ap_1/profile#
2
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Go to configure  AP configuration mode of CLI.
If there exists the same AP when entering [ap profile name], you are
guided to the mode where operator can configure the AP. If there is no
same AP, the new AP information is created.
Register the MAC address of the AP.
o profile mac [MAC_ADDRESS]
To check the information of a configured AP, use the 'show ap summary
config' command.
Click the <Add> button.
Set AP PROFILE NAME and MAC ADDRESS and click the <Apply>
button.
Go to configure  AP configuration  AP profile mode of CLI.
Configure the profile of an AP using the below command:
o name [STRING]: Configures the name of an AP. If it is not entered,
the 'AP_' + 'MAC address' is used as a name.
For example, MAC address: f4:d9:fb:24:cb:a0
AP name: AP_f4d9fb24cba0
173