Deep Packet Inspection
It supports QoS by application. It may allow drop, bandwidth contract, and DSCP marking
and it provides statistics by detailed category. The application of DPI in a unit of WLAN is
possible and it also provides a monitoring function.
Configuring Profile and Application Rule
A profile is a set of application rules and each rule includes the QoS settings of the
application.
The profile must set at least one application rule.
Configuration using CLI
1
APC# configure terminal
APC/configure# dpi
APC/configure/dpi#
2
APC/configure/dpi# profile [NAME]
APC/configure/dpi/profile [NAME]# rule [APPLICATION]
APC/configure/dpi/profile [NAME]/rule [APPLICATION]# action permit
APC/configure/dpi/profile [NAME]/rule [APPLICATION]# mark [DSCP]
APC/configure/dpi/profile [NAME]/rule [APPLICATION]# bw-contract upstream [BW_CNT]
APC/configure/dpi/profile [NAME]/rule [APPLICATION]# bw-contract downstream [BW_CNT]
APC/configure/dpi/profile [NAME]# enable
3
APC# configure terminal
APC/configure# wlan [ID]
APC/configure/wlan [ID]# dpi-profile [NAME]
Configuration using Web UI
In the menu bar of <WEC Main Window>, select <Configuration>, and then select
<Wireless QoS > Application QoS> in the submenus. Select <Profile>.
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Enter the DPI Configuration mode.
Make a profile and add an application rule.
Parameter
NAME
APPLICATION
DSCP
BW_CNT
Designate a WLAN where the profile is applied.
Parameter
NAME
ID
Description
Profile name
Application name
DSCP value
Bandwidth Contract. Kbps
Description
Profile name
WLAN ID
114