Energy Saving Auto Classification - Samsung WEC8500 Operation Manual

submenus.

Energy Saving Auto Classification

The purpose of the AP is to reduce power consumption of the APC by turning off the RF
radio of the AP. This occurs without the connected STA at a specific time when the STA
connected to the APC is drastically reduced. The APs of the APC are classified into an
active and a standby group. The active group keeps them at the operational status all the
time whereas the standby group makes their RF radio off at the designated time. When
the APC designates a standby group (energy saving group), the others are recognized as
an active group.
Up to 20 groups can be designated (Same as WEC8500/WEC8050).
Energy Saving Auto Classification is not a method under which the operator configures a
standby group but a method under which the system automatically classifies an energy
saving group by using the analysis of each AP.
For the convenience of the operator, the existing Energy Saving Groups and Energy
Saving Auto Classification functions can be used by mixture. In short, as shown in the
existing method, only Energy Saving Groups or only Energy Saving Auto Classification or
both can be used.
Configuration using CLI
1
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
Enable/Disable: Check the configuration of whether the Energy Saving
Auto Classification function operates.
(Enable: Function operation, Disable: No function operation)
303