Country Code - Samsung WEC8500 Operation Manual

Country Code

You can use a country code to restrict the number of channels that can be used in an AP
and the maximum transmission power of each channel.
Configuration using CLI
To configure the country code function, go to country mode first by executing the following
command:
APC# configure terminal
APC/configure# country
APC/configure/country#
[Global Country Code Configuration]
If you configure a global country code, the country code can be specified to all the
connected APs at the same time. The command is shown below.
•
To check the configuration information, use the 'show country global-config' command.
[AP Country Code Configuration]
To configure a country code, execute the command as follows:
•
To check the configuration information, use the 'show country ap-config [AP_ID]'
command.
[AP Group Country Code Configuration]
To configure a country code, execute the command as follows:
•
To check the configuration information, use the 'show country group-config [AP group
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
set-global [COUNTRY_CODE] [VALUE]
Parameter
COUNTRY_CODE
VALUE
set-ap [AP_ID] [COUNTRY_CODE] [VALUE]
Parameter
AP_ID
COUNTRY_CODE
VALUE
set-group [AP group ID] [COUNTRY_CODE] [VALUE]
Parameter
AP group ID
COUNTRY_CODE
VALUE
Description
Country code to configure
Environment configuration (both/outdoor/indoor/none)
Description
AP ID (range: 1-500)
Country code to configure
Environment configuration (both/outdoor/indoor/none)
Description
AP group ID (range: 1-3000)
Country code to configure
Environment configuration (both/outdoor/indoor/none)
277