Retrieving and Configuring Threshold
If each resource of the system exceeds its configured threshold, there occurs an alarm.
The APC helps an operator check and configure each threshold.
Configuration using CLI
Use the below command to check each threshold.
•
•
•
•
•
To change a threshold related to CPU load or memory usage, enter the command as
follows:
•
•
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Administrator> and then select the
<SNMP> <APC> <Trap Control> <Alarm Threshold> menu in the sub-menus.
You can retrieve and configure a threshold at which CPU load, disk usage, temperature
alarm, memory usage, or fan alarm occurs. Enter a value for each item, and click the
<Apply> button to make the configuration applied.
WEC8500/WEC8050 (APC) Operation Manual v10.1
©Samsung Electronics America
show system threshold cpu: CPU load (%)
show system threshold memory: Memory usage (%)
show system threshold disk: Disk usage (%)
show system threshold fan: Fan RPM level
show system threshold temp: Retrieves system temperature (°C).
system monitor cpu threshold [THRESHOLD]: Configures the CPU load
threshold.
system monitor memory threshold [THRESHOLD]: Configures the
memory usage threshold.
Parameter
THRESHOLD
Description
Threshold to configure (%)
453