Replacing An Mx2000 Ac Power Supply Module; Removing An Mx2000 Ac Power Supply Module - Juniper MX2020 Hardware Manual

RELATED DOCUMENTATION
Preventing Electrostatic Discharge Damage to an MX2020 Router
Powering Off the DC-Powered MX2000 Router | 660
Troubleshooting the MX2000 Router Power System | 686
Maintaining the Power Supply Modules on the MX2000 Line of Routers | 418
MX2020 DC Power Distribution (240 V China) Description | 203
MX2020 DC Power Electrical Safety Guidelines
MX2000 Router DC Power Subsystem Electrical Specifications | 205

Replacing an MX2000 AC Power Supply Module

Removing an MX2000 AC Power Supply Module | 412

1.
Installing MX2000 Router AC Power Supply Modules | 415
2.
Removing an MX2000 AC Power Supply Module
Before you remove a PSM, be aware of the following:
CAUTION:
PSM, each PdSM slot must contain either a PSM or a blank panel. If you remove a
PSM, you must install a replacement PSM or a blank panel shortly after the removal.
NOTE: After powering off a PSM, wait at least 60 seconds before turning it back on.
To maintain proper cooling and prevent thermal shutdown of the operating
412