Installing The Ptx5000 In A Rack; Installing The Ptx5000 Mounting Hardware For A Four-Post Rack Or Cabinet; Installing Cage Nuts, If Needed - Juniper PTX5000 Hardware Manual

Installing the PTX5000 in a Rack

IN THIS SECTION

Installing the PTX5000 Mounting Hardware for a Four-Post Rack or Cabinet | 206

Installing the PTX5000 Mounting Hardware for an Open-Frame Rack | 211
Overview of Installing a PTX5000 Using a Mechanical Lift | 213
Tools Required to Install the PTX5000 Using a Mechanical Lift | 214
Installing the PTX5000 By Using a Mechanical Lift | 214
Installing the PTX5000 Mounting Hardware for a Four-Post Rack or
Cabinet
IN THIS SECTION

Installing Cage Nuts, If Needed | 206

Installing the Four-Post Mounting Shelf and Rear Support Bracket | 208
Removing the Center-Mounting Brackets | 209
Installing Cage Nuts, If Needed
Insert cage nuts, if needed, into the holes listed in
location). The hole distances are relative to the standard U division on the rack that is aligned with the
bottom of the mounting shelf and rear support bracket.
To install cage nuts in a four-post rack:
1. On the rear rack rails, insert cage nuts in the holes specified for the rear support bracket. Install the
cage nuts in the rear of the rear rail (see
2. On the front rack rails, insert cage nuts in the holes specified for the four-post mounting shelf. Install
the cage nuts in the front of the front rail (see
Table 1 and Table 2
Table 1).
Table 1).
(an X indicates a mounting hole
206