Step 3: Install the PTX5000 Mounting Hardware
IN THIS SECTION
Install the PTX5000 Mounting Hardware for a Four-Post Rack or Cabinet | 7
Install the PTX5000 Mounting Hardware for an Open-Frame Rack | 11
To install the mounting hardware, perform one of the following procedures:
Install the PTX5000 Mounting Hardware for a Four-Post Rack or Cabinet
Install Cage Nuts, If Needed | 7
1.
Install the Four-Post Mounting Shelf and Rear Support Bracket | 9
2.
Remove the Center-Mounting Brackets | 10
3.
Install Cage Nuts, If Needed
Insert cage nuts, if needed, into the holes listed in
a mounting hole location). The hole distances are relative to the standard U division on the rack that is
aligned with the bottom of the mounting shelf and rear support bracket.
To install cage nuts in a four-post rack:
1. On the rear rack rails, insert cage nuts in the holes specified for the rear support bracket. Install the
cage nuts in the rear of the rear rail (see
2. On the front rack rails, insert cage nuts in the holes specified for the four-post mounting shelf. Install
the cage nuts in the front of the front rail (see
3. On the front rack rails, insert cage nuts in the holes specified for mounting the chassis. Install the cage
nuts in the front of the front rail (see
Table 1 on page 8
Table 1 on page
8).
Table 1 on page
8).
Table 2 on page
8).
and
Table 2 on page 8
(an X indicates
7