Figure 41: Adjustable Mounting Brackets For Four-Post Rack Installation - Juniper EX8208 Complete Hardware Manual

Complete Hardware Guide for EX8208 Ethernet Switches
128

Figure 41: Adjustable Mounting Brackets for Four-Post Rack Installation

Position the right front adjustable mounting bracket at the desired position in the right
6.
side of the rack opposite the installed left front bracket, so that it is on the same rack
level as the left bracket. If the right and left front brackets are not on the same level,
the chassis will rest at an angle in the rack instead of resting flat and level. Line up the
right bracket's front screw holes with the holes in the rack. Use 4 mounting screws
appropriate for your rack to attach the right front bracket to the rack.
Position the other rear bracket at the right rear of the rack on the same level as the
7.
right front bracket, so that the rear bracket overlaps with the right front bracket. The
screw holes for connecting the front and rear brackets should overlap. Use 4 mounting
screws appropriate for your rack to attach the rear bracket to the rack.
Connect the right front and rear brackets (see Figure 41 on page 128):
8.
Insert 6 of the screws provided with the mounting brackets into the overlapping
a.
bracket holes.
Hand tighten the screws fully (to 12–16 in.-lb torque) using a number 2 Phillips
b.
screwdriver.
Copyright © 2010, Juniper Networks, Inc.