Connecting The Barcode Scanner; Setting Up Communications; Defining Send System Data Option - Siemens Rapidlab 1200 Operator's Manual

8-26

Connecting the Barcode Scanner

You need the a barcode scanner kit, including the barcode scanner, cable, and holder for
this activity.
NOTE:
number of the barcode scanner kit, refer to Supplies‚ page D-1.
WARNING:
damage to the system, remove power from the system as described in this
procedure.
Attaching the Barcode Scanner
1. Remove power from the system:
a. Select
CAUTION:
cartridges are installed. Cartridges installed in the system remain stable for 6
hours without power.
b. At the Shutdown screen, turn the power switch off.
2. Connect the barcode cable to the barcode scanner connector.
The barcode scanner connector is located on the back panel of the system and is
labeled with a barcode symbol.
3. Tighten the hold-down screws on the connector.
4. Attach the holder for the barcode scanner to the left side of the system.
5. Turn the on power switch.

Setting up Communications

Use the Communications screen to setup a time for sending system data, and setup
connections to external devices. For systems connected to an LIS, this screen can also be
used to select cSO2

Defining Send System Data Option

Use this procedure to define the time to automatically send system data to the e-mail
address defined by your local technical service provider.
1. At the Setup screen, select
2. Select
3. Enter the time to send the data.
4. Select
02087462 Rev. V
Use only the barcode scanner kit provided by the manufacturer. For the part
Do not proceed while the power is on. To prevent electrical shock or
Status > Shutdown
Do not remove power from the system for more than 6 hours if
.
Send System Data
.
Save
Rapidlab 1200 Operator's Guide: System Configuration
.
Printer and Devices > Communications
.