Table of Contents
Advertisement
8-30
Using DHCP
Use this procedure to use dynamic host configuration protocol.
1. Select the communication settings at the Rapidlab 1200 system:
a. At the Setup screen, select
b. Select
c. If you want to change the name for the Rapidlab 1200 system, select
d. Select
e. Select
f.
2. When prompted that the connection was unsuccessful, select
3. Connect the network cable to the RJ-45 connector on the back panel of the
Rapidlab 1200 system.
4. At the Rapidlink or Rapidcomm workstation, enter the communication settings.
Refer to the Rapidlink Supervisor's Manual or Rapidcomm User's Guide.
5. At the Rapidlab 1200 system, select
6. Select
7. To complete any additional setup that may be necessary to operate the Rapidlab 1200
system with the Rapidlink or Rapidcomm program, refer to the Rapidlink Supervisor's
Manual or Rapidcomm User's Guide.
Selecting sO
Transmission (LIS only)
You can report sO2 values to the LIS as a measured or calculated value. The cSO2 and
msO2 buttons are grayed out if the system is not connected to an LIS.
1. At the Setup screen, select
2. Select
3. Select
Connecting to a Laboratory Information System
Use this procedure to connect the Rapidlab 1200 system to a hospital or laboratory
information system (LIS) using a serial (RS-232) connection. Refer to the Rapidlab 1200
Interface Specification Manual to configure a hospital or laboratory information system
for the Rapidlab 1200 system.
You need an interface cable for this activity.
02087462 Rev. V
CompleNet > Configure
and enter the name for the Rapidlab 1200 system.
Rapidlab 1200
.
Continue
Use DHCP > Save
At the Communications screen, select
.
Return
as a Measured or Calculated Value for LIS
2
or
.
cSO2
msO2
.
Save
Rapidlab 1200 Operator's Guide: System Configuration
Printer and Devices > Communications
.
.
.
Save
.
Save
Printer and Devices > Communications
.
.
Continue
.
Advertisement
Table of Contents
Troubleshooting
