Rapidlab 1200 Operator's Guide: System Configuration
2. Change the date and time.
If you want to...
change the date,
change the time,
3. Select
Setting up the Sound
You can adjust the volume for system sounds and videos, and turn off the sound
that occurs when you select buttons.
NOTE:
your attention, are always on.
1. At the Setup screen, select
2. Adjust the volume or turn the sound off.
If you want to...
adjust the volume for the system
sound,
adjust the volume for the video
sound,
turn off the sound that occurs
when you touch buttons,
3. Select
Setting up Other Options
Use this procedure to enter a name that identifies the system and the phone
number for technical support. The system displays the name and phone number on
the System Information screen, but the system prints only the system name on
printed reports.
1. At the Setup screen, select
2. Enter the telephone number.
3. Select
4. Select
Then...
a.
Select
b.
Enter the date in the format shown on the screen.
Enter a leading zero before numbers less than 10. For
example, if the date format is mm/dd/yyyy, enter
February 4, 2007 as 02042007.
a.
Select
b.
Enter the time in 24-hour format.
Enter a leading zero before numbers less than 10. For
example, enter 10:07 PM as 2207.
.
Save
Other sounds, such as beeps that alert you to system events that require
Save.
and then enter a name for the system.
System Name
.
Save
.
Date
.
Time
System Options > Sound
Then...
a.
Select a number for the system volume level.
b.
Select
to hear the volume at that level.
Preview
a.
Select a number for the video volume level.
b.
Select
to hear the volume at that level.
Preview
select
.
Touch Sound
System Options > Other Options
8-21
.
.
02087462 Rev. V