Installing New System Software - Siemens Rapidlab 1200 Operator's Manual

8-42
You need a formatted 1.44 MB 3.5-inch diskette or 1 CD to complete this activity.
1. At the Setup screen, select
If you want to...
save Setup data,
restore Setup data or copy Setup data from another system,
2. Select the appropriate drive (disk or CD).
3. When prompted, insert a disk or CD into the appropriate drive and select
4. When prompted, remove the diskette or CD from the drive and select
5. Store the diskette or CD in a safe place, away from heat and strong magnetic sources
such as centrifuges.

Installing New System Software

You can install new system software from a CD-ROM, disks, or from a network
connection. To install software from a network connection, your system must be
configured for a network and be connected to a device that provides access to the new
system software.
You need the following materials to perform this task:
• Disks containing the Rapidlab 1200 system software
• CD-ROM containing the Rapidlab 1200 system software
You can copy patient, QC, and calibration data to a disk or CD. Refer to Copying Data
Files‚ page 7-2.
02087462 Rev. V
Rapidlab 1200 Operator's Guide: System Configuration
.
Secured Options
select...
.
Save Setup
.
Restore Setup
Continue
.
Continue
.