Siemens Rapidlab 1200 Operator's Manual page 43

Rapidlab 1200 Operator's Guide: System Overview and Intended Use
Parameter
Custom Panels
If you define custom panels for your system, the system displays the custom
panels in the lower-left corner of the Analysis screen. Each of the panel buttons
displays the parameters that are in that panel. The number buttons, 1 and 2,
represent the 2 sets of panels currently available on the system.
The system displays the buttons only when panels are defined. Refer to Defining
Custom Panels‚ page 8-11.
1
2
Figure 1-25
Sampling Modes on the Analysis Screen
To simplify patient analysis tasks, the Rapidlab 1200 systems have 4 modes of
operation:
Mode
Microsample
pH
tHb
pH, Glu, Lac
Description
Parameter is not available for analysis because Required QC was
not performed when scheduled (the button is purple). Refer to
Troubleshooting the Yellow Parameter Error‚ page 6-1.
Custom panel buttons
Panel set buttons
Custom Panel Buttons
Description
Use the Microsample mode when you have insufficient sample
for patient analysis in the default sampling mode.
Use the pH mode when you analyze samples for a pH result only.
Use the tHb mode when you analyze samples for tHb,
hemoglobin fractions, and oxygenation parameters only (for
Rapidlab 1245 and 1265 systems).
Use the pH, Glu, Lac mode to test for pH, Glucose, and Lactate
only.
1-23
02087462 Rev. V