Siemens Rapidlab 1200 Operator's Manual page 438

G-2
LIS
Potentiometry
Prime AQC Cartridge test
Printer test
RCx
Reagent Flow test
R Valve
Sample Chamber
Sample Pump
Sensors
Temperature test
Voltage and Temperatures
test
Wash Pump
Waste Detector Calibration
Wavelength Cal
02087462 Rev. V
Rapidlab 1200 Operator's Guide: Glossary
Laboratory Information System.
Measures the voltage or potential generated between 2
electrodes in an electrochemical cell when no external
current is applied and the cell is in a state of equilibrium
moves the individual levels of QC material while you
verify proper flow, Priming the AQC Cartridge‚
page 6-37
prints all printable characters providing the system ID,
the date and time of the report, and the printer data,
Performing Tests and Printing Diagnostic Reports‚
page 6-34
A calibrator contained in the wash cartridge.
moves the individual reagents (200 cal and Slope cal
from the reagent cartridge and wash and RCx from the
wash cartridge) while you verify proper fluid flow,
Performing the Reagent Flow Tests‚ page 6-36
moves the valve for the reagent cartridge to prescribed
positions, Performing the R Cartridge Valve Test‚
page 6-40
verifies the proper operation of the CO-ox sample
chamber and prints the results, Performing the CO-ox
Pump Test‚ page 6-42
Only on the Rapidlab 1245 and 1265 systems.
moves the sample pump at various speeds, Performing
the Sample Pump and Wash Pump Tests‚ page 6-39
outputs the raw sensor signals in mV or nA
For Field Service use only.
prints the temperature for various system components
and the current pAtm providing the system ID, the date
and time of the report, and temperature information,
Performing Tests and Printing Diagnostic Reports‚
page 6-34
prints the voltage and temperatures, Performing Tests
and Printing Diagnostic Reports‚ page 6-34
moves the wash pump at various speeds, Performing the
Sample Pump and Wash Pump Tests‚ page 6-39
calibrates the waste detector, Performing the Waste
Detector Calibration‚ page 6-35
verifies the proper operation of the CO-ox neon lamp
and prints the results providing the system ID, the date
and time of the report, Performing the Wavelength Cal
Test‚ page 6-46
Only on the Rapidlab 1245 and 1265 systems.