Connecting The Service Pc; Configuration Of The Service Pc; Configuration Of Computer Bios; Configuration Of Windows® 2000 Pro - Siemens MAMMOMAT Novation DR Installation Manual

Appendix
BIOS
XXX
XXX

Connecting the service PC

The service PC must be connected with connecting cable part no. 99 00 440 RE999 to the
p.c. board in the generator (do not insert the diskette in the drive yet).

Configuration of the service PC

All Service Programs use the RS232 port in order to communicate with the MAMMOMAT.
This port is usually handled as COM1 by the OS of the service PC. Modern PC's can be
equipped with new types of communication hardware, e.g. infrared port and built-in
modem, which may act as COM1 or share resources with COM1. This could cause mal-
function of the Service Programs for the MAMMOMAT, which requires the OS and com-
puter BIOS to be re-configured.
The following procedures are designed to ensure general compatibility with the OS's
Windows
done only once.

Configuration of computer BIOS

1.
2.
3.
4.
5.
Configuration of Windows
1.
2.
3.
4.
5.
6.
Siemens AG
Medical Solutions
Basic Input and Output System, a program stored in the computer
hardware which launches start-up functions upon computer
power-up.
XXX This shows where a particular subroutine can be found.
XXX For example:
Main menu
®
2000 Pro on modern PC's. If the settings are saved, this procedure has to be
Enter the BIOS setup, usually done by pressing e.g. <F2> during the boot
sequence of the BIOS.
Find the configuration of the IrDA (Infrared device) port and disable it.
Find the configuration of a built-in modem and make sure it is configured as
COM3.
Find the configuration of COM1 and make sure it uses the interrupt IRQ 4 and the
memory address range 03F8 - 03FF.
Save the BIOS settings and restart the PC.
Choose Settings from the Start Menu.
Choose Control Panel.
Choose System.
Choose the tab Hardware.
Press the button Device Manager.
If the IrDA-port was disabled in the computer BIOS, it should not be present in the
list of available hardware. If the IrDA is present anyway and its icon is not marked
with a red cross:
Double-click on the device row.
Configuration
®
2000 Pro
SPB7-250.815.02
Rev. 02 09.04
AEC Sensitivity correction
MAMMOMAT Novation
Page 5 of 8
CS SD 24
12 - 5
12
12
12
12
DR
System