Show Fc-Redirect Active-Configs - Cisco MDS 9000 series Command Reference Manual

Chapter 22 Show Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

show fc-redirect active-configs

To display all active configurations on a switch, use the show fc-redirect active-configs command.
Syntax Description
This command has no other arguments or keywords.
Defaults None.
Command Modes EXEC mode.
Command History Release
3.2(1)
Usage Guidelines This command is used to verify that there are no active configurations running on the switch during the
following operations:
•
•
Active configuration implies configurations created by applications running on the current switch or
Note
applications created on remote switches for hosts or targets connected to the local switch.
Examples The following example displays the active configurations running on the switch.
switch# show fc-redirect active-configs
Config#1
==========
Appl UUID
SSM Slot
SSM Switch WWN
Vt PWWN
Tgt PWWN
Local Host PWWN = 21:00:00:e0:8B:0d:12:c6
Config#2
==========
Appl UUID
SSM Slot
SSM Switch WWN
Vt PWWN
Tgt PWWN
Local Host PWWN = 21:00:00:e0:8B:0d:12:c6
OL-8413-07, Cisco MDS SAN-OS Release 3.x
show fc-redirect active-configs
Modification
This command was introduced.
Downgrading from 3.2.1 image (supporting FC-Redirect) to an older image where FC-Redirect is
not supported.
Decommissioning a local switch.
= 0x00D8 (ISAPI CFGD Service)
= 2
= 20:00:00:05:30:00:90:9e (LOCAL)
= 2f:ea:00:05:30:00:71:64
= 21:00:00:20:37:38:63:9e (LOCAL)
= 0x00D8 (ISAPI CFGD Service)
= 2
= 20:00:00:05:30:00:90:9e (LOCAL)
= 2f:ea:00:05:30:00:71:65
= 21:00:00:20:37:18:67:2c
show fc-redirect active-configs
Cisco MDS 9000 Family Command Reference
22-79