Ethernet 1 (Private), Ethernet 2 (Public), Ethernet 3 (External); Wan Interface In Slot N, Port A B; Status; Ip Address - Cisco VPN 3000 User Manual

3
Interfaces

Ethernet 1 (Private), Ethernet 2 (Public), Ethernet 3 (External)

To configure Ethernet interface parameters, click the appropriate highlighted link in the table or click in
a highlighted module on the back-panel image. See Configuration | Interfaces | Ethernet 1 2 3 .

WAN Interface in slot N, Port A B

To configure parameters for a specific WAN interface port, click the appropriate highlighted link in the
table. If you are configuring the WAN interface for the first time, see the Configuration | Interfaces | WAN
Card in Slot N | Port A B | Select T1/E1
N | Port A B as T1 or E1

Status

The operational status of this interface. If configured, the WAN interface status includes a prefix if PPP
Multilink is enabled, and the interface type (T1 or E1).
Up
Down
Testing
Dormant
connection.
Not Present
Lower Layer Down
Unknown
Not Configured
Red
out of frame errors or a mismatched framing format, or a disconnected line.
Blue
remote signal. This alarm indicates a problem in the data bit stream.
Yellow
the connection has detected a problem with this line).
Loopback
IP Address Not Configured
PPP Multilink and no longer has an IP address. To connect this port to a WAN, you must supply an

IP address.

IP Address
The IP address configured on this interface.

Subnet Mask

The subnet mask configured on this interface.
3-4
screen.
= (Green) Configured, enabled, and operational; ready to pass data traffic.
= (Red) Configured but disabled or disconnected.
= In test mode; no regular data traffic can pass.
= (Red) Configured and enabled but waiting for an external action, such as an incoming
= (Red) Missing hardware components.
= (Red) Not operational because a lower-layer interface is down.
= (Red) Not configured or not able to determine status.
= Present but not configured.
= (Red) (WAN only.) Red alarm: Line has lost synchronization or signal. This alarm indicates
= (Blue) (WAN only.) Blue alarm: A problem on the receive path is causing the line to lose the
= (Yellow) (WAN only.) Yellow alarm: A problem on the transmit side (the remote side of
= (WAN only.) Line is in loopback state.
screen. Otherwise, see the Configuration | Interfaces | WAN Card in Slot
= (WAN only) Interface port that was previously configured for
VPN 3000 Concentrator Series User Guide