Alert Groups; Associating An Alert Group Using The Cli - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Chapter 53 Configuring Call Home
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command
Step 4
switch(config-callhome)# destination-profile
test e-mail-addr person@place.com
Step 5
switch(config-callhome)# destination-profile
test message-size 1000000
Step 6
switch(config-callhome)# destination-profile
test format full-txt
switch(config-callhome)# destination-profile
test format short-txt
Steps 4, 5, and 6 in this procedure can be skipped or configured in any order.
Note

Alert Groups

An alert group is a predefined subset of Call Home alerts supported in all switches in the Cisco MDS
9000 Family. Different types of Call Home alerts are grouped into different alert groups depending on
their type. You can associate one or more alert groups to each profile as required by your network.
The alert group feature allows you to select the set of Call Home alerts to be received by a destination
profile (either predefined or user-defined). You can associate multiple alert groups with a destination
profile.
A Call Home alert is sent to e-mail destinations in a destination profile only if that Call Home alert
Note
belongs to one of the alert groups associated with that destination profile.

Associating an Alert Group Using the CLI

To associate an alert group with a destination profile, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# callhome
switch(config-callhome)#
Step 3
switch(config-callhome)# destination-profile
test1 alert-group test
switch(config-callhome)# destination-profile
short-txt-destination alert-group test
OL-18084-01, Cisco MDS NX-OS Release 4.x
Purpose
Configures the e-mail address for the user-defined
destination profile (test) sent in default XML
format.
Configures a maximum message size for the
destination e-mail addresses in the user-defined
destination profile (test) sent in default XML
format. The valid range is 0 to 1,000,000 bytes and
the default is 500,000. A value of 0 implies that a
message of any size can be sent.
Configures message-format for the user-defined
destination profile (test) to be full text format.
Configures message-format for the user-defined
destination profile (test) to be short text format.
Purpose
Enters configuration mode.
Enters Call Home configuration submode.
Optional. Configures user-defined destination
profile (test1) to receive all user-generated Call
Home test notifications.
Optional. Configures predefined short-text
destination profile to receive all user-generated
Call Home test notifications.
Cisco MDS 9000 Family CLI Configuration Guide
Alert Groups
53-9