Configuring Smart Call Home
Associating an Alert Group with a Destination Profile
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Example
The following example shows how to associate all alert groups with the destination profile Noc101:
switch# configuration terminal
switch(config)# callhome
switch(config-callhome)# destination-profile Noc101 alert-group All
switch(config-callhome)#
What to do next
Optionally, you can add show commands to an alert group and configure the SMTP e-mail server.
Adding Show Commands to an Alert Group
You can assign a maximum of five user-defined show commands to an alert group.
Procedure
Step 1
Step 2
Step 3
Command or Action
switch# configure terminal
switch(config)# callhome
switch(config-callhome)# destination-profile
name alert-group {All | Cisco-TAC |
Configuration | Diagnostic | Environmental
| Inventory | License | Linecard-Hardware |
Supervisor-Hardware | Syslog-group-port |
System | Test}
(Optional) switch# show callhome
destination-profile [profile name]
(Optional) switch(config)# copy
running-config startup-config
Command or Action
switch# configure terminal
switch(config)# callhome
switch(config-callhome)# alert-group
{Configuration | Diagnostic | Environmental
| Inventory | License | Linecard-Hardware |
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 7.x
Associating an Alert Group with a Destination Profile
Purpose
Enters global configuration mode.
Enters Smart Call Home configuration mode.
Associates an alert group with this destination
profile. Use the All keyword to associate all
alert groups with the destination profile.
Displays information about one or more
destination profiles.
Saves the change persistently through reboots
and restarts by copying the running
configuration to the startup configuration.
Purpose
Enters global configuration mode.
Enters Smart Call Home configuration mode.
Adds the show command output to any Call
Home messages sent for this alert group. Only
valid show commands are accepted.
65