Log Event-Host - Allied Telesis x510-28GTX Command Reference Manual

GUI C
OMMANDS
-
LOG EVENT HOST

log event-host

Overview Use this command to set up an external host to log AMF topology events through
Vista Manager. This command is run on the Master device.
Use the no variant of this command to disable log events through Vista Manager.
Syntax log event-host [<ipv4-addr>|<ipv6-addr>] atmf-topology-event
no log event-host [<ipv4-addr>|<ipv6-addr>] atmf-topology-event
Default Log events are disabled by default.
Mode Global Configuration
Usage Event hosts are set so syslog sends the messages out as they come.
NOTE
•
•
Example To enable Node 1 to log event messages from host IP address 192.0.2.31, use the
following commands:
Node1#
Node1(config)#
To disable Node 1 to log event messages from host IP address 192.0.2.31, use the
following commands:
Node1#
Node1(config)#
Related atmf topology-gui enable
Commands
C613-50170-01 Rev B
Parameter
<ipv4-addr>
<ipv6-addr>
: There is a difference between log event and log host messages:
Log event messages are sent out as they come by syslog
Log host messages are set to wait for a number of messages (20) to send
them out together for traffic optimization.
configure terminal
log event-host 192.0.2.31 atmf-topology-event
configure terminal
no log event-host 192.0.2.31 atmf-topology-event
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
ipv4 address of the event host
ipv6 address of the event host
224