Snmp Trap Link-Status - Hirschmann RS20 Reference Manual

4.6.55 snmp trap link-status

This command enables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled.
See 'snmp-server enable traps linkmode' command.
Format
snmp trap link-status
Mode
Interface Config
no snmp trap link-status
U
This command disables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is en-
abled. See 'snmp-server enable traps linkmode' command).
Format
no snmp trap link-status
Mode
Interface Config
186
4.6 Device Configuration Commands
CLI L2E
Release 8.0 05/2013