Snmp-Server Enable Traps Port-Sec - Hirschmann RS20 Reference Manual

CLI Commands: Base

4.4.51 snmp-server enable traps port-sec

This command enables port security traps. When the traps are enabled, a
Port Security Trap is sent if a port security event occurs
(applies to MAC/IP Port Security).
Default
enabled
Format
snmp-server enable traps port-sec
Mode
Global Config
no snmp-server enable traps port-sec
U
This command disables Port Security traps.
Format
no snmp-server enable traps port-sec
Mode
Global Config
118
4.4 Management Commands
Release 8.0 05/2013
CLI L2E