Snmp-Server Enable Traps Multiusers - Hirschmann RS20 Reference Manual

CLI Commands: Base

4.4.50 snmp-server enable traps multiusers

This command enables Multiple User traps. When the traps are enabled, a
Multiple User Trap is sent when a user logs in to the terminal interface (EIA
232 (serial port) or telnet) and there is an existing terminal interface session.
Default
enabled
Format
snmp-server enable traps multiusers
Mode
Global Config
no snmp-server enable traps multiusers
U
This command disables Multiple User traps.
Format
no snmp-server enable traps multiusers
Mode
Global Config
CLI L2E
Release 8.0 05/2013
4.4 Management Commands
117