4.8.21 device-status monitor
This command configures the device-status.
Format
device-status monitor
{aca-removal | all | connection-error |
hiper-ring |
module-removal | power-supply-1 |
power-supply-2 | power-supply-3-1 |
power-supply-3-2 |power-supply-4-1 |
power-supply-4-2 | ring-coupling | temperature }
{error|ignore}
device-status trap {disable|enable}
Mode
Global Config
monitor
Determines the monitoring of the selected event or all events.
– error If the given event signals an error, the device state will also
signal error,
– ignore Ignore the given event - even if it signals an error, the
device state will not signal 'error' because of that.
trap
Configure if a trap is sent when the device status changes its state.
– enable enables sending traps,
– disable disables sending traps.
CLI L2E
Release 8.0 05/2013
4.8 System Utilities
235