Show Snmptrap - Hirschmann RS20 Reference Manual
Command line interface industrial ethernet gigabit switch
Hide thumbs
Also See for RS20:
- Reference manual (572 pages) ,
- User manual (294 pages) ,
- Programming manual (116 pages)
Table of Contents
Advertisement
CLI Commands: Base
4.4.29 show snmptrap
This command displays SNMP trap receivers. Trap messages are sent
across a network to an SNMP Network Manager. These messages alert the
manager to events occurring within the switch or on the network. Six trap re-
ceivers are simultaneously supported.
Format
show snmptrap
Mode
Privileged EXEC
SNMP Trap Name
The community string of the SNMP trap packet sent to the trap man-
ager. This may be up to 32 alphanumeric characters. This string is
case sensitive.
IP Address
The IP address to receive SNMP traps from this device. Enter four
numbers between 0 and 255 separated by periods.
Status
A pull down menu that indicates the receiver's status (enabled or dis-
abled) and allows the administrator/user to perform actions on this
user entry:
Enable - send traps to the receiver
Disable - do not send traps to the receiver.
Delete - remove the table entry.
CLI L2E
Release 8.0 05/2013
4.4 Management Commands
99
Advertisement
Table of Contents
