Show Device-Status - Hirschmann RS20 Reference Manual

CLI Commands: Base

4.1.12 show device-status

The signal device status is for displaying
D
the monitoring functions of the switch,
D
the device status trap setting.
Format
show device-status
[monitor|state|trap]
Mode
Privileged EXEC and User EXEC
Device status monitor
Displays the possible monitored events and which of them are
monitored:
– the detected failure of at least one of the supply voltages.
– the removal of the ACA
– the removal of a media module
– the temperature limits
– the defective link status of at least one port. With the switch, the
indication of link status can be masked by the management for each
port. Link status is not monitored in the delivery condition.
– the loss of Redundancy guarantee.
Ring/network coupling:
– The following conditions are reported in Stand-by mode:
– interrupted control line
– partner device running in Stand-by mode.
HIPER-Ring:
– The following condition is reported in RM mode additionally:
– Ring redundancy guaranteed. Ring redundancy is not monitored in
the delivery condition.
Device status state
Error The current device status is error.
No Error The current device status is no error.
Device status trap
enabled A trap is sent if the device status changes.
disabled No trap is sent if the device status changes.
CLI L2E
Release 8.0 05/2013
4.1 System Information and Statistics
47