Set Igmp Groupmembershipinterval - Hirschmann RS20 Reference Manual

4.6.21 set igmp groupmembershipinterval

This command sets the IGMP Group Membership Interval time on the sys-
tem. The Group Membership Interval time is the amount of time in seconds
that a switch will wait for a report from a particular group on a particular inter-
face before deleting the interface from the entry. This value must be greater
than the IGMP Maximum Response time value. The range is 3 to
3,600 seconds.
Default
260
Format
set igmp groupmembershipinterval <3-3600>
Mode
Global Config
no set igmp groupmembershipinterval
U
This command sets the IGMP Group Membership Interval time on the
system to 260 seconds.
Format
no set igmp groupmembershipinterval
Mode
Global Config
156
4.6 Device Configuration Commands
CLI L2E
Release 8.0 05/2013