Snmp Trap Listing - Hirschmann MACH 4000 User Manual

Operation diagnosis

9.1.1 SNMP trap listing

All the possible traps that the Switch can send are listed in the following table.
Trap name
authenticationFailure
coldStart
hmAutoconfigAdapterTrap is sent when the ACA Auto Configuration Adapter is removed or
linkDown
linkUp
hmTemperature
hmPowerSupply
hmSigConRelayChange
newRoot
topologyChange
risingAlarm
fallingAlarm
hmPortSecurityTrap
hmModuleMapChange
hmBPDUGuardTrap
hmMrpReconfig
hmRingRedReconfig
hmRingRedCplReconfig
hmSNTPTrap
hmRelayDuplicateTrap
lldpRemTablesChange-
Trap
vrrpTrapNewMaster
vrrpTrapAuthFailure
Table 14: Possible traps
Basic - L3P
Release 4.0 11/07
Meaning
is sent if a station attempts to access an agent without permission.
is sent for both cold and warm starts during the boot process after
successful management initialization.
plugged in again.
is sent if the link to a port is interrupted.
is sent as soon as the link to a port is re-established.
is sent if the temperature exceeds the set threshold value.
is sent if the status of the voltage supply changes.
is sent if the status of the signal contact changes during the oper-
ation monitoring.
is sent if the sending agent becomes a new root of the spanning
tree.
is sent if the transmission mode of a port changes.
is sent if an RMON alarm input exceeds the upper threshold.
is sent if an RMON alarm input falls below the lower threshold.
is sent if a MAC/IP address is detected at the port which does not
correspond to the current settings of – hmPortSecPermission and
– hmPorSecAction set either to trapOnly (2) or portDisable (3).
is sent if the hardware configuration is changed.
is sent if a BPDU is received at a port even though the BPDU
Guard function is active.
is sent if the configuration of the MRP-Ring changes.
is sent if the configuration of the HIPER-Ring changes.
is sent if the configuration of the redundant ring/network coupling
changes.
is sent if errors occur in connection with the SNTP (e.g. server can-
not be reached).
is sent if a duplicate IP address is detected in connection with
DHCP Option 82.
is sent, if an entry in the topology table is changed.
is sent if a different router becomes the master for an interface or
a virtual address.
is sent if the router receives a packet with invalid authentication
from another VRRP router.
9.1 Sending traps
3