Cable-Crossing - Hirschmann RS20 Reference Manual

4.6.5 cable-crossing

Note: This function is available for the RS20/RS30/RS40, MS20/MS30,
RSR20/RSR30, MACH1000, PowerMICE and OCTOPUS devices.
Use this command to enable or disable the cable crossing function.
Note: The cable-crossing settings become effective for a certain port, if
auto-negotiate is disabled for this port.
The cable-crossing settings are irrelevant for a certain port, if
auto-negotiate is enabled for this port.
Format
cable-crossing {enable|disable}
Mode
Interface Config
cable-crossing enable
The device swaps the port output and port input of the TP port.
cable-crossing disable
The device does not swap the port output and port input of the TP
port.
140
4.6 Device Configuration Commands
CLI L2E
Release 8.0 05/2013