Bridge Address-Learning; Bridge Address-Relearn Detect Operation - Hirschmann RS20 Reference Manual

CLI Commands: Base

4.4.2 bridge address-learning

To enable you to observe the data at all the ports, the Switch allows you to
disable the learning of addresses. When the learning of addresses is dis-
abled, the Switch transfers all the data from all ports to all ports. The default
value is enable.
Format
bridge address-learning {disable|enable}
Mode
Global Config

4.4.3 bridge address-relearn detect operation

This command enables or disables Bridge Address Relearn Detection.
The default value is disable.
Default
Disabled
Format
bridge address-relearn detect operation
{disable|enable}
Mode
Global Config
80
4.4 Management Commands
Release 8.0 05/2013
CLI L2E