Class Of Service (Cos) Commands - Hirschmann RS20 Reference Manual
Command line interface industrial ethernet gigabit switch
Hide thumbs
Also See for RS20:
- Reference manual (572 pages) ,
- User manual (294 pages) ,
- Programming manual (116 pages)
Table of Contents
Advertisement
CLI Commands: Base
4.3 Class of Service (CoS)
Commands
This chapter provides a detailed explanation of the QoS CoS commands.
The following commands are available.
The commands are divided into these different groups:
D
Configuration Commands are used to configure features and options of
the switch. For every configuration command there is a show command
that will display the configuration setting.
D
Show commands are used to display device settings, statistics and other
information.
Note: The 'Interface Config' mode only affects a single interface, whereas the
'Global Config' mode is applied to all interfaces.
CLI L2E
Release 8.0 05/2013
4.3 Class of Service (CoS) Commands
71
Advertisement
Table of Contents
