Storm-Control Broadcast (Port-Related); Storm-Control Egress-Limit - Hirschmann RS20 Reference Manual

4.6.63 storm-control broadcast (port-related)

This command enables the broadcast limiter per port.
Enter the maximum number of broadcasts that the given port is allowed to
send (unit: frames per second, min.: 0 (no limit), default: 0 (no limit)).
Format
storm-control broadcast <max. broadcast rate>
Mode
Interface Config

4.6.64 storm-control egress-limit

Note: This command is available for the RS20/RS30/RS40, MS20/MS30 and
OCTOPUS devices.
Sets the egress rate limit in kbit/s. "0" means: no limit.
Format
storm-control egress-limit <max. egress rate>
Mode
Interface Config
192
4.6 Device Configuration Commands
CLI L2E
Release 8.0 05/2013