Device Configuration Commands; Auto-Disable Reason - Hirschmann RS20 Reference Manual

4.6 Device Configuration
Commands

4.6.1 auto-disable reason

This command enables the port disabling on this device by reason.
Default
Disabled
Format
auto-disable reason
{link-flap | crc-error | overload-detection}
Mode
Global Config
link-flap
Enable the port disabling on this device by link flap.
crc-error
Enable the port disabling on this device by CRC error.
overload-detection
Enable the port disabling on this device by overload detection.
CLI L2E
Release 8.0 05/2013

4.6 Device Configuration Commands

135